Author Topic: New 7.0.27 firmware available  (Read 3438 times)

Offline deepsnow

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Re: New 7.0.27 firmware available
« Reply #45 on: August 09, 2018, 02:27:45 pm »
I started a new thread, but probably should have just posted in this thread. I am confused by the 7.0.27 firmware version, since I do not see that anywhere.

Anyway, everything was working perfectly until I did this update.

Now, my lights turn on at sunset, but never turn off. I have to manually reboot my Vera Plus every morning, then I can turn the lights off through the web interface.

I can see the event is being triggered like it should, but the communication seems lost with my z-wave LED bulbs until I reboot. I can still communicate with my door lock, so it is just my 3 z-wave light bulbs.

I have 4 of these Vera Plus units in 4 different homes. This is the only one I have upgraded. Soon I will not be at this house to reboot the controller every morning, so my home automation is no longer automated.

Any ideas?

Is there an automatic reboot scheduler I can run in the middle of the night that would simulate me rebooting the controller?

Can I downgrade firmware?

Any other things to try?

Thank you,
Scott

Offline HSD99

  • Sr. Member
  • ****
  • Posts: 255
  • Karma: +8/-0
Re: New 7.0.27 firmware available
« Reply #46 on: August 10, 2018, 04:30:07 pm »
7.0.27 is the release version. The specific software versions of 7.0.27 for each Vera controller are shown below:

https://support.getvera.com/customer/en/portal/articles/2944393

* Vera3, VeraLite, & VeraLite G: 1.7.1040
* VeraEdge: 1.7.4000
* VeraPlus: 1.7.4001
* VeraSecure: 1.7.4002

And yes, this is confusing.

Offline shawnky

  • Sr. Newbie
  • *
  • Posts: 23
  • Karma: +0/-0
Re: New 7.0.27 firmware available
« Reply #47 on: August 13, 2018, 08:40:55 pm »
I knew better than to update... I'll eventually learn... Lights = Orange Power, Green WAN...