Author Topic: Garage Door Control (FortrezZ MIMO Lite Relay) ~ ERROR  (Read 101 times)

Offline Sammy2

  • Hero Member
  • *****
  • Posts: 855
  • Karma: +4/-5
Garage Door Control (FortrezZ MIMO Lite Relay) ~ ERROR
« on: August 02, 2018, 07:10:50 pm »
ERROR: Unable to get any information on node

This relay gives this error but seems to still be working. Again, this happened after the last f/w update. How to get rid of this error?

On a side note, the wall switch in the garage quit working about the same time, intermittently.

Thanks.
« Last Edit: August 06, 2018, 06:03:47 pm by Sammy2 »

Offline Sammy2

  • Hero Member
  • *****
  • Posts: 855
  • Karma: +4/-5
Re: Garage Door Control (FortrezZ MIMO Lite Relay) ~ ERROR
« Reply #1 on: August 06, 2018, 06:04:21 pm »
Anyone?
Bueler?
Bueler?

Offline Sammy2

  • Hero Member
  • *****
  • Posts: 855
  • Karma: +4/-5
Re: Garage Door Control (FortrezZ MIMO Lite Relay) ~ ERROR
« Reply #2 on: August 07, 2018, 02:31:19 pm »
Okay. This is what I've done thus far..

I excluded a Motion Sensor and power-cycled the Garage Door Opener Relay. I the re-included the Motion Sensor but I think I chose the wrong model. It paired but said it was a AEON not a Zooz so it is not reliably connected. OTOH, the Garage Door Relay is happy and the near-by Christmas Lights in-box switch is as well. Issues with my Pool Pumps seem to have gone away too but that was always intermittent so time will tell if it comes back. Things are looking up!