We have moved at community.getvera.com

Author Topic: Temperature control - Vera plus and qubino  (Read 396 times)

Offline krystianl

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Temperature control - Vera plus and qubino
« on: July 20, 2018, 01:07:07 pm »
Hello,
I am a beginner and I am asking you for help which qubino module I should use.
I have Vera plus with UI7, firmware 1.7.4001
I would like have thermostat as device in my Vera and switch to turn on the light.
Should I use qubino ZMNHND1 ?
If I use ZMNHND1 then in my Vera I will see 2 devices: thermostat and switcher?

And my second questions about temperature settings.
Qubino thermostats show temperature inside room, and by arrows you can change the temperature (current setpoint).

Which code lua I should use, if I want to get:

If temperature inside is smaller than current setpoint then
.....

I do not know how to do this condition :/

I'm sorry for my english and I hope you understand me and help me if it is possible.

Thank you very much

Offline Ionut A

  • Global Moderator
  • Jr. Member
  • *****
  • Posts: 68
  • Karma: +1/-0
Re: Temperature control - Vera plus and qubino
« Reply #1 on: August 29, 2018, 08:13:52 am »
Hello krystianl,

Qubino ZMNHND1 Flush 1D relay is displayed on the UI as a switch device, not as a thermostat. If you want to use a thermostat in your HA system, I recommend to choose a thermostat from the compatibility list: http://getvera.com/compatibility/

As for the scenario you want to achieve, I'd suggest to open a ticket by sending an email to support@getvera.com