Author Topic: Monoprice Dual Relay 11990 - Device Type  (Read 1308 times)

Offline wadingriver

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Monoprice Dual Relay 11990 - Device Type
« on: September 12, 2018, 04:22:53 pm »
Vera Plus UI7
Monoprice Dual Relay 11990

I could use some help on how to configure the VP to show both switches and both output signals.  I added it as a generic  z-wave type, but it only shows as a single on/off switch.   I did successfully change a tilt switch to show all of its capabilities, but I'm really stumped on this one.

Any help is greatly appreciated

Offline Maegda

  • Customer Care
  • Global Moderator
  • Jr. Member
  • *****
  • Posts: 79
  • Karma: +1/-0
Re: Monoprice Dual Relay 11990 - Device Type
« Reply #1 on: September 13, 2018, 04:50:55 am »
Hello wadingriver,

I sent you an email, I will need to have a look at the configuration of this device.

Thank you!
Vera Control, Ltd.  Smarter Home Control
support@getvera.com  +1 (866) 966-2272

Offline wadingriver

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Re: Monoprice Dual Relay 11990 - Device Type
« Reply #2 on: September 13, 2018, 07:14:50 am »
Thank you for your reply.  Between my email and your email, I have seemed to have solved my dilemma.  I found that adding the device as a Qubino Flush 2 Relay, the parent switch and the two independent switches now show up correctly.