Author Topic: 2gig image sensors and verasecure?  (Read 158 times)

Offline green1

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
2gig image sensors and verasecure?
« on: September 13, 2018, 10:54:30 pm »
I have a couple of 2gig image sensors left over from a previous automation system, and was excited to see that the verasecure supports 2gig. Unfortunately I can't find these devices in the list anywhere.

Any hints for getting these working?
Model: adc-is-221-lp

These are basically a PIR motion sensor with an extremely lousy black and white night vision still camera tacked on. I don't care so much if the "image" part works, but would love to get the extra motion detectors going as you can never have too many of those in an automation setup!

Offline Maegda

  • Customer Care
  • Global Moderator
  • Jr. Member
  • *****
  • Posts: 92
  • Karma: +2/-1
Re: 2gig image sensors and verasecure?
« Reply #1 on: September 14, 2018, 08:24:17 am »
Hello green1,

I will add a device integration request for this sensor to be analyzed.
 
Note that VeraSecure has what is called VeraLink. As mentioned on the VeraSecure description VeraLink supports only the following 2GIG devices at this time:
Door/window sensors (3 variations), motion sensor, smoke detector, carbon monoxide detector, glass break sensor, tilt sensor, keyfob (4 buttons) and a panic button.

Regards,



Vera Control, Ltd.  Smarter Home Control
support@getvera.com  +1 (866) 966-2272