Author Topic: HomeSeer HS-WD200+ Support on Vera  (Read 255 times)

Offline bobbydoedoe

  • Sr. Newbie
  • *
  • Posts: 33
  • Karma: +1/-0
HomeSeer HS-WD200+ Support on Vera
« on: October 13, 2018, 07:04:40 pm »
I recently purchased a HomeSeer HS-WD200+ assuming the LED status light is supported by Vera, but I was wrong.  I purchased this device in hopes I could utilize the led lights to tell me the status of Vera.  ie: away=show red led light, home=show blue led light, etc.  But since the led light configuration is not supported in vera, I am stuck.  I know from researching, the end user can config the led lights using LUUP but I am new in that area.  Does anyone have any writeup as to how to control the led light in vera either thru LUUP or other means?  thanks in advance

Offline bobbydoedoe

  • Sr. Newbie
  • *
  • Posts: 33
  • Karma: +1/-0
Re: HomeSeer HS-WD200+ Support on Vera
« Reply #1 on: October 15, 2018, 12:46:22 am »
I was able to get it to work via the use of luup and pleg via the change of device parameter with the following code:
I have copy/paste the code into pleg under device actions =>LUUP, i hope this helps:

luup.call_action('urn:micasaverde-com:serviceId:ZWaveNetwork1','SendData',{Node='57',Data='112 4 21 1 1'},1)


57=device number, it is the altid number
112=leave as is
4=leave as is
21=parameter# to change first led (the bottom light)
1=leave as is
1=change led to red color
1=leave as is

see page 4 of this pdf for a listing of parameter codes to the led color of your choice
https://homeseer.com/wp-content/uploads/2018/02/HS-WD200-Manual-4.pdf