We have moved at community.getvera.com

Author Topic: Aeotec LED - help needed setting parameter 34  (Read 396 times)

Offline Nomer

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Aeotec LED - help needed setting parameter 34
« on: October 19, 2018, 08:26:09 am »
I have just installed two Aeotec gen5 LEDs with my VeraPlus and want to set it so that toggling the lightswitch (not a bell press) will change the on/off status.  I understand these are the settings:
   Parameter 34 [1 byte].
   Value 0 = Disable [default]
   Value 1 = Enable

Both of these bulbs are operated from the one switch (2 bulbs on the one light fitting), so I am hoping I can get this to work so that toggling twice will operate both bulbs sequentially, but if there is any advice on this pit would be appreciated. 

My main request for help is how do I set this parameter? I haven't set parameters in this interface before (1.7.4001) and can't work out how to do it.  Can someone point me in the right direction?


Offline Sorin

  • Administrator
  • Hero Member
  • *****
  • Posts: 1134
  • Karma: +103/-11
Re: Aeotec LED - help needed setting parameter 34
« Reply #1 on: October 19, 2018, 08:48:18 am »

Go to that device's settings by pressing " > " icon, on the device box, then press "Device Options"  -> "Add configuration settings" , to insert a new line, and add the parameters. Then save.

Hope this helps.
Sorin M. ▾ Community Manager
Vera Control, Ltd. ▾ Smarter Home Control  ▾ support@getvera.com ▾www.getvera.com ▾ +1 (866) 966-2272

HOURS OF OPERATION for Customer Care Department - 24/7