Author Topic: Wallmote switching fibaro rgbw individual channels  (Read 180 times)

Offline safiery

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Wallmote switching fibaro rgbw individual channels
« on: October 19, 2018, 05:44:40 pm »
I?ve setup Aeotec Wallmote Quad to switch the individual led light channels on Fibaro rgbw. This is all 12v environment (cabin). However I can?t get the switches to operate individual end point IDs. I can see the multichannel associations with end point ID but just can?t get it to work. Comments please

Offline Helen

  • Global Moderator
  • Sr. Newbie
  • *****
  • Posts: 48
  • Karma: +0/-0
Re: Wallmote switching fibaro rgbw individual channels
« Reply #1 on: October 22, 2018, 03:56:11 pm »
Good evening,


Please note that we have opened a trouble ticket in our system for this subject, please reply there.

Thank you.

Offline MarcusB

  • Jr. Member
  • **
  • Posts: 62
  • Karma: +1/-0
Re: Wallmote switching fibaro rgbw individual channels
« Reply #2 on: November 22, 2018, 04:57:27 am »
You can also just use the inputs to directly control the rgbw switches. Each input is factory configured to control one output.  The benefit of this is itworks even if Vera isn?t working.
You do need to be able to get the wires from the rgbw unit to the switch plate but it?s only 12v and on a boat there probably isn?t too much distance.