Author Topic: Fibaro Univeral Sensor / Temperature Sensor - Vera Plus Setup  (Read 1775 times)

Offline spefora

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Fibaro Univeral Sensor / Temperature Sensor - Vera Plus Setup
« on: October 21, 2018, 07:49:51 pm »
Hi,

I am new to Vera, so please excuse possible stupid questions  ;)

I setup Vera Plus and then added successfully Fibaro Wall plug with no problem (already existing in the devices list)

Then I tried adding Fibaro Universal Sensor which is connected only to a DS18B20 temp sensor (cabling rippled checked).

The device was not in the device list so I added it as a generic Z Wave device.

Then I got 3 new devices: 2 Binary sensors and one Universal sensor.

I suppose that the universal sensor is the temp sensor (or am I wrong and this refers t the module itself and not the temp sensor attached which is not added at all?)

I cannot see how I can get the temp reading from the sensor.

I noticed that in device settings all 3 new devices are mentioned as motion sensors.

Reading this http://www.dreamgreenhouse.com/reviews/2012/fibaro_us/ I changed 'device_file' entry to 'D_TemperatureSensor1.xml (in the universal sensor device) but no luck.

Thanks in advance for your help.

PS If there is a link with general instructions for similar setup issues, please let me know.

Offline Radu B

  • Global Moderator
  • Sr. Newbie
  • *****
  • Posts: 39
  • Karma: +0/-0
Re: Fibaro Univeral Sensor / Temperature Sensor - Vera Plus Setup
« Reply #1 on: October 22, 2018, 04:49:37 am »
Hello,

Please know that I have replied into the ticket that you created into our system. Please take a look.

Thank you.  :)