Author Topic: Danfoss LC 13 Not communicating after batter change  (Read 320 times)

Offline col8eral

  • Sr. Member
  • ****
  • Posts: 354
  • Karma: +3/-2
Danfoss LC 13 Not communicating after batter change
« on: October 24, 2018, 03:31:18 am »
My Danfoss LC 13 batteries run out. Changed them and now I can't change the setpoint from my Vera unit. The interface says waiting for wake-up to send commands.

Any advice how I can get this working again.

Offline reneboer

  • Beta Testers
  • Hero Member
  • *****
  • Posts: 1423
  • Karma: +81/-30
Re: Danfoss LC 13 Not communicating after batter change
« Reply #1 on: October 24, 2018, 04:29:20 am »
Hi,

Assuming you see the display light up and can control using the buttons on the LC13 itself, and you used normal batteries, not rechargeable ones. You can wake up the device by pressing the bottom button once. Always works for me. If not you may need to exclude and include.

Cheers Rene
2xVeraLite, VeraEdge, openLuup, ALTUI, 20 switches, 10 dimmers, 20 sensors, 10 scene controllers, 1 Harmony Hub, many plug-ins. Not enough time.

Offline col8eral

  • Sr. Member
  • ****
  • Posts: 354
  • Karma: +3/-2
Re: Danfoss LC 13 Not communicating after batter change
« Reply #2 on: October 24, 2018, 04:33:33 am »
Many thanks. Tried that. No luck.

I did a comma test and I've got the bell and antenna icons blinking.

Offline reneboer

  • Beta Testers
  • Hero Member
  • *****
  • Posts: 1423
  • Karma: +81/-30
Re: Danfoss LC 13 Not communicating after batter change
« Reply #3 on: October 25, 2018, 05:20:10 am »
Try to take it off the radiators and then try to include it close to your Vera. Not sure these support network wide inclusion yet.

Cheers Rene
2xVeraLite, VeraEdge, openLuup, ALTUI, 20 switches, 10 dimmers, 20 sensors, 10 scene controllers, 1 Harmony Hub, many plug-ins. Not enough time.