Author Topic: Partly Solved: Unplugged rfxcom, after connecting back it's not working anymore.  (Read 201 times)

Offline VeraEdger

  • Full Member
  • ***
  • Posts: 112
  • Karma: +1/-0
I used the rfxcommngr in Windows to program a Somfy motor. Choosing the id's and the program option gave me the blinds going down/up a bit. Great.

Then I connected the rfxcom back to Vera, but... it's not seen anymore. There is a LUA startup failure. HUH... it was working with KAKU 15 minutes ago.
Rebooted Vera with rfxcom connected, but....nope still nothing.

Any idea?
« Last Edit: November 25, 2018, 06:18:11 am by VeraEdger »

Offline VeraEdger

  • Full Member
  • ***
  • Posts: 112
  • Karma: +1/-0
Re: Unplugged rfxcom, after connecting back it's not working anymore.
« Reply #1 on: November 25, 2018, 06:17:08 am »
Hmmm Got it working again. Still some advice please.

I renamed the device. So it seems I had to configure the serial port again, as the name changed.
It this once? Or do I have to configure always after a reboot?

What's the procedure for unplugging rfcxom?

Offline tinman

  • Full Member
  • ***
  • Posts: 212
  • Karma: +13/-0
I believe you had the transceiver connected previously using a different plugin. When you reconnected using the new plugin it is seen as a new device - thus the need to configure the serial port. There should be no need to do this again.

Offline VeraEdger

  • Full Member
  • ***
  • Posts: 112
  • Karma: +1/-0
Thanks.

Just tried again, pulling it out and putting it back in. Working fine.