Author Topic: Z-Wave: Is it possible to forward a multilevel report to a device?  (Read 306 times)

Offline tobsch

  • Newbie
  • *
  • Posts: 8
  • Karma: +0/-0
I own the eurotronic zwave spirit. It supports receiving external temperature readings via SENSOR_MULTILEVEL_REPORT, which is unfortunately not supported by my external sensors. Is there any way to send a raw "SENSOR_MULTILEVEL_REPORT" and include the temperature of an external sensor to a specific device?
If so, how can this be done?

Many thanks,

Tobias

Offline Maegda

  • Customer Care
  • Global Moderator
  • Jr. Member
  • *****
  • Posts: 92
  • Karma: +2/-1
Re: Z-Wave: Is it possible to forward a multilevel report to a device?
« Reply #1 on: December 12, 2018, 02:28:43 pm »
Hello tobsch,

Know that the eurotronic zwave spirit is not fully implemented with Vera.

The user manual mentions it can receive temperature readings from other Z-Wave devices but this feature has to be enabled via configuration parameter.

Parameter Number 8
Parameter Size 1
Parameter Name Measured temperature offset
Parameter Values
-50 to 50 (Default)   Offset in 1/10 Celcius
-128Temperature is supplied externaly

Is the parameter set? What kind of external sensors do you use? Are they also added on Vera?

Regards,

Vera Control, Ltd.  Smarter Home Control
support@getvera.com  +1 (866) 966-2272

Offline tobsch

  • Newbie
  • *
  • Posts: 8
  • Karma: +0/-0
Re: Z-Wave: Is it possible to forward a multilevel report to a device?
« Reply #2 on: December 17, 2018, 01:55:46 pm »
I for example use a Multisensor bei Aeotec, ideally, I would be able to convert all readings to the right format and retransmit it with vera.
Is that possible? I know that both devices are not originally compatible.

Offline tobsch

  • Newbie
  • *
  • Posts: 8
  • Karma: +0/-0
Re: Z-Wave: Is it possible to forward a multilevel report to a device?
« Reply #3 on: December 30, 2018, 06:30:45 am »
Hello tobsch,

Know that the eurotronic zwave spirit is not fully implemented with Vera.

The user manual mentions it can receive temperature readings from other Z-Wave devices but this feature has to be enabled via configuration parameter.

Parameter Number 8
Parameter Size 1
Parameter Name Measured temperature offset
Parameter Values
-50 to 50 (Default)   Offset in 1/10 Celcius
-128Temperature is supplied externaly

Is the parameter set? What kind of external sensors do you use? Are they also added on Vera?

Regards,

Hi Magda,

again my question is: Can I somehow send such a MULTILEVEL_SENSOR report as raw message via VERA?
See page 16 of this doc: https://products.z-wavealliance.org/ProductManual/File?folder=&filename=Manuals/2543/Spirit%20Z-Wave%20Plus_DRAFT_V4.pdf

Best,

Tobias