Author Topic: MIMO2+ input setup  (Read 127 times)

Offline cahilj

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
MIMO2+ input setup
« on: February 05, 2019, 09:49:25 pm »
I'm not sure if this is the right forum for this or not.

I've searched the board for MIMO2 info. I've found several people using the relay outputs just fine, but I haven't seen anyone using the voltage inputs.

When paired, I get 6 devices
-parent
-rel1
-rel2
-_GET_LANG(generic_sensor,sensor)
-_GET_LANG(generic_sensor,sensor) 1
-_GET_LANG(generic_sensor,sensor) 2

The relays work as they should.

Has anyone gotten the inputs to do anything in Vera? I can get them to register on the MIMO2, and I've tried changing the device type to a few different sensors, but nothing in Vera.

Offline Radhawan

  • Apprentice
  • Global Moderator
  • Sr. Newbie
  • *****
  • Posts: 37
  • Karma: +1/-0
  • I find your lack of faith disturbing
Re: MIMO2+ input setup
« Reply #1 on: February 06, 2019, 04:11:23 am »
Hello,

I have opened you a support ticket in regards to this issue.

Please check your email whenever you can.

If you need further assistance please reply to that email and we will get back to you.