We have moved at community.getvera.com

Author Topic: Re: Setup  (Read 874 times)

Offline glaso

  • Jr. Member
  • **
  • Posts: 59
  • Karma: +0/-0
Re: Setup
« on: November 18, 2010, 04:38:51 pm »
@Futzle Thanks for this development, seems promising

I have a noob question: Is it possible to use alarm sensors to trigger other events in Vera? For example, Is it possible to trigger a light if the alarm detects movement through one of its movement sensors?

thanks!!

Offline guessed

  • Community Beta
  • Master Member
  • ******
  • Posts: 5301
  • Karma: +92/-22
  • Release compat is not a bolted-on afterthought
Re: Re: Setup
« Reply #1 on: November 18, 2010, 04:45:45 pm »
Yes, the "Zones" in the Alarm panel show up as motion sensors in MiOS (Vera).  To Vera, these "look" the same as a ZWave motion sensor, so any Events from them can be used to trigger lights (etc) to go on via standard MiOS Scenes.

Offline glaso

  • Jr. Member
  • **
  • Posts: 59
  • Karma: +0/-0
Re: Re: Setup
« Reply #2 on: November 19, 2010, 08:34:57 am »
Hi Gussed / Fotzle, thanks for your answer... Is this pligin working fine with no bugs?

Offline futzle

  • Moderator
  • Master Member
  • *****
  • Posts: 3260
  • Karma: +192/-9
Re: Re: Setup
« Reply #3 on: November 19, 2010, 06:48:46 pm »
Is this pligin working fine with no bugs?

Ha, no code is without bugs...  but seriously, I've been using it in my house for weeks without incident.  I'm keen to get others to test different configurations, so that I can iron out any issues that might still lurk in the code.