Author Topic: Fibaro Motion Sensor  (Read 78974 times)

Offline ppdan

  • Newbie
  • *
  • Posts: 17
  • Karma: +0/-0
Re: Fibaro Motion Sensor
« Reply #210 on: November 06, 2017, 08:43:34 am »
hi stefanradu5,
open the GUI, go to Devices, select 3 in 1 sensor (the main one, not the specific for temperature or light), go to device options, add configuration settings, add what you need based on documentation.
Go to advanced, commands, configure node right now. You need to put the device in inclusion mode with the physical button so that it would accept the config change. It might take a couple of trials until it works.