We have moved at community.getvera.com

Author Topic: NX6 and nx584e Enrolling Problems  (Read 1113 times)

Offline farzu

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
NX6 and nx584e Enrolling Problems
« on: June 23, 2014, 07:43:17 pm »
My NX6 is not allowing me to program the NX-584e.
I have the programming code and without the NX-584e connected I can program fine, everythings ok.  As soon as I connect the 584e via the 3 wires I can't reliably get into programming mode.  *8 is okay consistently but then when asked for programming code it works very intermittently.  When I finally get in and I'm to enter 72#, after I hit # it kicks me out (Back to System Ready screen on the LCD, on the LED keypad, it just blocks).  I'm starting to think my NX-584e is messed up or it was never meant to work with the nx6.  Anyone experience this and has suggestions?

Offline futzle

  • Moderator
  • Master Member
  • *****
  • Posts: 3260
  • Karma: +192/-9
Re: NX6 and nx584e Enrolling Problems
« Reply #1 on: June 24, 2014, 05:41:44 am »
Ouch. That does sound wrong. Personally I don't have either the NX-6 or the NX-584E, so it's not surprising that I haven't seen this happen on my system. Most users here seem to use the built-in serial port on an NX-8E. But maybe someone reading this thread will know.