Author Topic: PowerLinc Modem 2412S to Vera3  (Read 1502 times)

Offline SJMarty

  • Jr. Member
  • **
  • Posts: 50
  • Karma: +1/-0
PowerLinc Modem 2412S to Vera3
« on: September 25, 2014, 09:13:05 pm »
Hello,

I've scanned through quite a few search results but have not been able to find an answer to my current situation.

I currently have an X10 setup and I'm in the process of converting to Z-Wave.  So far, I have a Vera3 and 15 Leviton VRPD3-1LW lamp modules.  In my X10 setup, I have a HomeRunner RBI connected to a PowerLinc Modem 2412S (v3.5 1027 if it matters).  Currently, the 2412S connects to the serial interface on the HomeRunner via a standard RJ45 cable.  The jack on the 2412S is not an Ethernet interface.  It is an RJ45 jack that is just labeled "Interface Cable". 

So, my question is...what cable should I use to connect the 2412S to the Vera3?  If such a beast doesn't exist, I think I could take one of my APC UPS USB interface cables and hack something together.  But...I will need to know what the pinouts on both ends.  Help!
Vera3 (UI7) | Amazon Echo

Offline Juppers

  • Jr. Member
  • **
  • Posts: 75
  • Karma: +2/-1
Re: PowerLinc Modem 2412S to Vera3
« Reply #1 on: September 26, 2014, 12:20:47 am »
The pins are described at http://www.insteon.com/pdf/2413Sqs.pdf I believe they are the same for the 2412 and 2413.

Offline SJMarty

  • Jr. Member
  • **
  • Posts: 50
  • Karma: +1/-0
Re: PowerLinc Modem 2412S to Vera3
« Reply #2 on: September 29, 2014, 10:27:41 am »
Has anyone had success using this cable?

If not, what cable are others using to connect their PLM to the V3?
Vera3 (UI7) | Amazon Echo