Beta and Pre-Release (Public) > UI4 Brainstorming & Discussion
Please include "AND" as a scene trigger
TimAlls:
For those who say it can't be done.....look at the logic in this Insteon Controller:
http://www.universal-devices.com/docs/isy99_userguide.pdf
It makes me rethink the use of Insteon......especially now that they have RF dimmers!
Thanks for the encouragement .... I will be posting more software tomorrow. It's just for Windows right now....I am checking on a Mac Version, but it is a ways off.
Regards
Tim
nickrwym:
As a new Vera owner I am very disappointed with the scenes limitations, I am planning on using it to control the heat pump as a result of inside and outside temperatures and scenes like
"Run pump for 5 minutes every 45 minutes IF outside temperature is below 4 degrees C" as a "stop things icing up" routine are not easy.
Using Vera with a temperature sensor as the heat pump controller and having different temperatures set for different times of day again seem not to be easy, timers don't do what I expect
Again using a motion sensor to trigger the heating in the day so that "if temperature below set point AND motion detected then turn on heat pump if it is between 9am and 5pm" are not there in a scene
I'm posting here to say "yes please" to the functionality being added, I am disappointed it's not there
Decent logging, record inside temperature, outside temperature, and 3 clamps of energy consumption would also make life much more useful
Nick
Navigation
[0] Message Index
[*] Previous page
Go to full version