We have moved at community.getvera.com

Author Topic: axa remote 2.0 rv2900 window opener  (Read 3442 times)

Offline gijs

  • Sr. Newbie
  • *
  • Posts: 20
  • Karma: +3/-0
axa remote 2.0 rv2900 window opener
« on: June 25, 2015, 07:05:43 pm »
A very nice non z-wave device is the axa remote 2.0. This device is able to open and lock windows. It comes with a infrared remote, but it is not possible to capture and copy this infrared signal. It is possible to hard wire a remote, but a nice way is to control the device via the rj12 port. This is a lin bus (data). A lot of information can be found on domoticaforum, including schematic.

http://www.domoticaforum.eu/viewtopic.php?f=8&t=496&start=60

At the moment i am able to control the unit via an arduino via a simple arduino sketch and some open close and stop buttons.
I think there are some possibilities to make a mysensor.org sensor or an ethernet gateway in combination with a vera plugin. Help is welcome because i am not the best programmer.

attachments
axa schematic credits to domorob
axa.zip with arduino sketch
axa picture of the device
« Last Edit: September 08, 2015, 09:58:32 am by gijs »

Offline Otje

  • Full Member
  • ***
  • Posts: 214
  • Karma: +6/-1
Re: axa remote 2.0 rv2900 window opener
« Reply #1 on: January 06, 2017, 01:05:32 pm »
Hi

i want to try the same. i purchased a few AXA openers, and i want to try to switch it using ESP8266, so that the window opener is connected to Wifi as well.

i dont prefer to use the communication interface, but use hardwired switches, like the optional AXA remote also does...
i hope to give an update after some time.

do you have furhter information on this device, i.e. the exact connections?
VERA Plus, VERA 3 Lite , couple of PIR's, several switch units, wall mounted tablet, Sonos integration with TTS, Temperature sensors, Imperihome, Zwave LED bulbs

Offline Otje

  • Full Member
  • ***
  • Posts: 214
  • Karma: +6/-1
Re: axa remote 2.0 rv2900 window opener
« Reply #2 on: February 06, 2017, 02:14:20 pm »
Hi

i managed to get it working, i connected it to the ESP8266 (Wemos D1 mini)

not on zwave though,,, but working

see my post at:

http://www.letscontrolit.com/forum/viewtopic.php?f=2&t=2245&p=13079#p13079
VERA Plus, VERA 3 Lite , couple of PIR's, several switch units, wall mounted tablet, Sonos integration with TTS, Temperature sensors, Imperihome, Zwave LED bulbs