I loved Watou's Nest plugin on UI5.
But since I got a Vera Edge and UI7 (1.7.1248), I had some intermittent problems with the Nest plugin, so I uninstalled and tried the "official" WWN plugin from MCV. It's much worse. I have heat and AC and my Nest is set in Auto-mode, so has two different setpoints. I couldn't change either one through the WWN plugin. I read a previous post that said MCV support suggested to put the Nest in either Heat or Cool mode, not Auto. That's not an option for me.
So, out of curiosity, I tried re-installing Watou's Nest plugin on UI7. It actually works and also gives me the "ModeState" to indicate if my furnace is Idle, Heating, or Cooling - something that the WWN plugin did not.
The only shortcoming with the Nest plugin seems to be that the current temperature, and set points are automatically rounded up to the next degree celcius. Is there any chance that this small issue could be fixed? Then it'd be perfect and I'd have accurate visibility and control of Nest through Vera again.
Watou? Please.
p.s. Another observation is that when I use the Nest Plugin through the AutHomation app, it does actually allow me to adjust the set points by 0.5 degrees, but it's just that the display of the setpoints is rounded up.