We have moved at community.getvera.com

Author Topic: Successful (ish) Upgrade  (Read 1007 times)

Offline dirtymurt

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Successful (ish) Upgrade
« on: August 21, 2015, 04:42:42 am »
I have upgraded from Vera lite to Vera Edge with a fair degree of success

Updated firmware on new box, set up new account, migrated settings from old box, upgraded old box to UI7 and now both boxes are seen on the network with new box as Master and old box as slave.

however, on the old box 2 of my sensors appear perfectly normally, one is an outside motion sensor and one is a Stella-Z TRV, but these devices are shown as not responding on my new box.

Questions then,

1) is this normal, should I delete the devices from the new master box?
2) should both boxes have all devices, is it safe to remove duplicates from the old box (except ones in the vicinity of that box)

Tip, when transferring, ensure your boxes are close together and make sure to update old box to UI7 afterwards or they dont play nice