Author Topic: MultiWave v3.4  (Read 1045 times)

Offline Wilder4u

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
MultiWave v3.4
« on: August 23, 2015, 03:41:16 pm »
Just received and installed a new Multiwave controller and remote which is running 3.4 firmware.
I followed MultiWave directions for including a controller into a Third Party Controller.
It created a scene controller on my VeraLite Network.  Im not sure where to go from here - the scene controller looks nothing like a pool controller.
Anyone else running 3.4?

Offline wilme2

  • Hero Member
  • *****
  • Posts: 1020
  • Karma: +18/-13
Re: MultiWave v3.4
« Reply #1 on: November 20, 2015, 12:53:44 pm »
How did this turn out?  I need to do our community pool (2 pumps for pool, 1 pump for hot tub + heater) and wanted to see how 3.4 is working...

Hoping for big electricity savings as we normally spend around $1000 per month on electricity.  (I had it way down in the off-season when I was directly involved - want automation so we can keep that up without having to constantly check the manual timers).
« Last Edit: November 20, 2015, 12:57:22 pm by wilme2 »
Long Live UI5!