Author Topic: Vision Security ZD2102 How to activate External Sensor  (Read 710 times)

Offline vijaysub

  • Newbie
  • *
  • Posts: 6
  • Karma: +1/-0
Vision Security ZD2102 How to activate External Sensor
« on: November 15, 2015, 09:38:19 pm »
I am trying to setup a couple of ZD2102 to use with a float switch on my fish tank to alarm when the water levels are too high.  The reed switch works well but I can't get the external switch to trigger on a vera lite.  On review of the manual  (http://products.z-wavealliance.org/MarketCertification/File?folder=&filename=MarketCertificationFiles/988/ZD%202102_04162014%20-%20500系列.pdf)

I need to add a 0x01 parameter and set it to 0xFF

I tried to add it as a new service 0x01
0xFF

But it doesn't seem to work.  Any recommendations?

Vijay

Offline r4arnys

  • Newbie
  • *
  • Posts: 13
  • Karma: +0/-0
Re: Vision Security ZD2102 How to activate External Sensor
« Reply #1 on: April 26, 2016, 02:19:13 pm »
I'm surprised there were no replies as I haven't seen the solution elsewhere - but I am new to all this.
Following on from what you said - as I had the same problem - I managed to get the external reed switch working on a Vera Plus (UI7) but not by adding a variable, instead going to "Device Options" and the "add configuration setting" adding variable 1 as a 1 byte decimal and value=255 (instead of the default 0) - saved changes then had to wake it up by taking the cover off and it worked.

Offline REKEMP10

  • Newbie
  • *
  • Posts: 14
  • Karma: +0/-0
Re: Vision Security ZD2102 How to activate External Sensor
« Reply #2 on: January 20, 2019, 11:59:19 am »
This is an old post but wanted to confirm that what r4arnys posted worked for me.  The documentation seemed to be clear that it was a 2 byte hex with FF as the value but that dkd not work for me...