We have moved at community.getvera.com

Author Topic: New 1.7.719 Firmware installed ==> Backup : ERROR: Backup failed...  (Read 1241 times)

Offline JJLINK

  • Newbie
  • *
  • Posts: 12
  • Karma: +0/-0
With the new 1.7.719 Firmware installed, I can no-longer backup the Zwave network.
I get this:
Backup : Backing up 0 of 16383
ZWave : Configuring Z-Wave devices in your system.

Backup : ERROR: Backup failed. Please try again.
ZWave : Configuring Z-Wave devices in your system.

Can someone else try it and see if they get similar results. Thanks


Follow up: I tried doing the Zwave backup a few hours later and it appears to be backing up. However it still says this:

 Last Z-Wave Network Backup: N/A

It is highly recommended to make a z-wave network backup before creating your controller full backup.
« Last Edit: November 22, 2015, 05:04:52 pm by JJLINK »

Offline logread

  • Full Member
  • ***
  • Posts: 214
  • Karma: +7/-1
Re: New 1.7.719 Firmware installed ==> Backup : ERROR: Backup failed...
« Reply #1 on: November 23, 2015, 01:37:41 am »
Quote
. However it still says this:

 Last Z-Wave Network Backup: N/A

Did you refresh your browser (ctrl F5) ?
Vera Lite UI7, Fibaro FGS-221, FGS-212, FGSS-001, FGK-101, FGWPE/F-101, FGMS-001, Aeon HEM G2, GreenWave PowerNode 6,  Everspring ST-814, SE-812, Swiid SwiidInter.
Raspberry Pi2 Raspbian w/ openLuup. AltUI, SV Thermostat, Virtual Switch, Weather (openWeather), System Monitor (openSysMon), HomeWave.

Offline reneboer

  • Beta Testers
  • Hero Member
  • *****
  • Posts: 1574
  • Karma: +110/-31
Re: New 1.7.719 Firmware installed ==> Backup : ERROR: Backup failed...
« Reply #2 on: November 23, 2015, 05:32:22 am »
On mine it took some minutes but the Zwave was backed up fine.

Cheers Rene
2xVeraLite, VeraEdge, openLuup, ALTUI, 20 switches, 10 dimmers, 20 sensors, 10 scene controllers, 1 Harmony Hub, many plug-ins. Not enough time.

Offline Spanners

  • Sr. Member
  • ****
  • Posts: 265
  • Karma: +16/-5
Re: New 1.7.719 Firmware installed ==> Backup : ERROR: Backup failed...
« Reply #3 on: November 23, 2015, 06:50:57 am »
With the new 1.7.719 Firmware installed, I can no-longer backup the Zwave network.
I get this:
Backup : Backing up 0 of 16383
ZWave : Configuring Z-Wave devices in your system.

Backup : ERROR: Backup failed. Please try again.
ZWave : Configuring Z-Wave devices in your system.

Can someone else try it and see if they get similar results. Thanks


Follow up: I tried doing the Zwave backup a few hours later and it appears to be backing up. However it still says this:

 Last Z-Wave Network Backup: N/A

It is highly recommended to make a z-wave network backup before creating your controller full backup.

I'm having the same issue.  :-\