Author Topic: AD2USB getting started manual or link ?  (Read 1118 times)

Offline MrAutomate

  • Full Member
  • ***
  • Posts: 209
  • Karma: +8/-8
AD2USB getting started manual or link ?
« on: November 26, 2015, 10:10:24 am »
Kevin @ Nutech has been great helping me get my AD2USB talking to my alarm panel, and that works fine now.  Next step is connecting to vera.

I have not seen a getting started guid with step by step instructions (ie install plugin , configure these parameters, etc, on these screens in UI7, etc, etc).

If you have successfully  installed this device in UI7, and can please point me in the right direction, I would appreciate any help you can give!

Thanks

Offline MrAutomate

  • Full Member
  • ***
  • Posts: 209
  • Karma: +8/-8
Re: AD2USB getting started manual or link ?
« Reply #1 on: January 09, 2016, 09:00:27 am »
Bump.

I can confirm the AD2USB on the laptop can control and see the alarm panel.  The serial port on Vera shas been enabled by VERA tech support, I no longer get a cannot communicate message, both the partition and the Alarm panel plugin now have no errors.

I enter my PIN code, press store, and get a success message.  I cannot get any further, and need some help.  Not sure what to enter on the CHEAT SHEET section.  Does the system, when correctly configured, create a device on its own automatically?

Thanks for any help! ???



Online DeltaNu1142

  • Hero Member
  • *****
  • Posts: 1148
  • Karma: +40/-67
Re: AD2USB getting started manual or link ?
« Reply #2 on: January 09, 2016, 10:09:49 am »
Fair warning: I have zero experience with UI7. But the best resource for your questions is this page:

http://code.mios.com/trac/mios_vista-alarm-panel-ad2usb/wiki

The system will not create its own device. You'll need to install and configure the plugin as instructed on that page. Good luck.
Vera 3 @ UI5 | HomeWave | PLEG

Offline MrAutomate

  • Full Member
  • ***
  • Posts: 209
  • Karma: +8/-8
Re: AD2USB getting started manual or link ?
« Reply #3 on: January 09, 2016, 10:13:15 am »
@ DeltaNu1142 .  Thanks, that is very helpfull.  I was looking for a UI7 version, but it may not have changed.  I think my issue is :

http://forum.micasaverde.com/index.php/topic,26993.0.html

Waiting for my laptop to charge before I head over to the panel and try that out.  Thanks again for the advice!