Cree Connected A19 Bulb is a no go. Previously it was paired with a Wink Hub and it worked fine. I tried multiple times to add it to VeraPlus. Each time it would add, but you would get a "Failed to configure" message and it couldn't be controlled. Tried setting device to "Automatically configure = yes", but that didn't work. Curiously, the web page icon showed it as a Zwave device with On and OFF, but no dimming. I ended up resetting it and re-pairing it with my Wink Hub. I did not leave it in this state overnight to see if that would fix it though.
BTW, the instructions on Cree's site to reset the bulb did not work on mine. I found the following instructions to reset online and it worked for me.
Start with the bulb off
Flash on
Leave off 2 seconds
Flash on
Leave off 2 seconds
Flash on
Leave off 2 seconds
Turn on
Light should blink once quickly to indicate it has been reset.
HTH,
-bob