Author Topic: 2852-222, Insteon Leak Sensor On Vera edge  (Read 1212 times)

Offline BillC

  • Sr. Newbie
  • *
  • Posts: 33
  • Karma: +0/-0
2852-222, Insteon Leak Sensor On Vera edge
« on: March 15, 2016, 08:19:01 pm »
Has anyone used these?  I like the form factor-just set it on the ground.
I got it installed and armed it but it doesn't seem to send an alert
Thanks

Bill

Offline wystewart

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Re: 2852-222, Insteon Leak Sensor On Vera edge
« Reply #1 on: March 16, 2016, 08:45:14 pm »
How are you using it?  Directly in Vera Edge or through altseon?  If direct, I would not be surprise it does not work.  vera does not update the status of the switches, so I expect the same for the sensor.  might work through Alsteon if it supports it.

Offline BillC

  • Sr. Newbie
  • *
  • Posts: 33
  • Karma: +0/-0
Re: 2852-222, Insteon Leak Sensor On Vera edge
« Reply #2 on: March 17, 2016, 10:48:22 am »
Just using it directly.  I didn't know about Alsteon.  I did figure out one problem, I realized it wasn't even recognizing the event locally, the light on the unit never went red when I shorted the contacts, so I have a defective unit.  Requesting a replacement and then I will try again. 

Thanks for the reply

Offline hax0rmort

  • Full Member
  • ***
  • Posts: 110
  • Karma: +9/-5
Re: 2852-222, Insteon Leak Sensor On Vera edge
« Reply #3 on: June 25, 2016, 11:54:34 pm »
the leak sensors work perfectly with altsteon.  I am using five right now on my Vera Plus.

Offline hsmaier

  • Jr. Member
  • **
  • Posts: 59
  • Karma: +0/-0
Re: 2852-222, Insteon Leak Sensor On Vera edge
« Reply #4 on: April 25, 2017, 07:10:59 pm »
Just using it directly.  I didn't know about Alsteon.  I did figure out one problem, I realized it wasn't even recognizing the event locally, the light on the unit never went red when I shorted the contacts, so I have a defective unit.  Requesting a replacement and then I will try again. 

Thanks for the reply

Bill

Did you ever get the leak sensor to work? I just bought one and expected it to work just like my other Insteon Switches.
Sadly it does not send an alert. I have a Vera 2 on U15
I spoke to Insteon technical support but they were not familar with Vera.

Thoughts?

Howard
Vera 2 U14, Vera 2 U15, Two Trane TZEMT400AB32 Thermostats. Insteon Light Switches, Insteon Outlets, Power Linc Modem.