2852-222, Insteon Leak Sensor On Vera edge

[BillC]

Has anyone used these?  I like the form factor-just set it on the ground.
I got it installed and armed it but it doesn't seem to send an alert
Thanks

Bill

[wystewart]

How are you using it?  Directly in Vera Edge or through altseon?  If direct, I would not be surprise it does not work.  vera does not update the status of the switches, so I expect the same for the sensor.  might work through Alsteon if it supports it.

[BillC]

Just using it directly.  I didn't know about Alsteon.  I did figure out one problem, I realized it wasn't even recognizing the event locally, the light on the unit never went red when I shorted the contacts, so I have a defective unit.  Requesting a replacement and then I will try again. 

Thanks for the reply

[hax0rmort]

the leak sensors work perfectly with altsteon.  I am using five right now on my Vera Plus.

[hsmaier]

Just using it directly.  I didn't know about Alsteon.  I did figure out one problem, I realized it wasn't even recognizing the event locally, the light on the unit never went red when I shorted the contacts, so I have a defective unit.  Requesting a replacement and then I will try again. 

Thanks for the reply

Bill

Did you ever get the leak sensor to work? I just bought one and expected it to work just like my other Insteon Switches.
Sadly it does not send an alert. I have a Vera 2 on U15
I spoke to Insteon technical support but they were not familar with Vera.

Thoughts?

Howard