Author Topic: Can't Detect Device with Vera Plus  (Read 1706 times)

Offline CheckedOut

  • Sr. Newbie
  • *
  • Posts: 32
  • Karma: +1/-0
Can't Detect Device with Vera Plus
« on: March 28, 2016, 01:28:00 pm »
I have installed the AD2USB Vista Plugin on my Vera Plus and am having some issues. The panel I am using is the ADT Safewatch 3000.

The "Ademco Vista Alarm Panel" device shows up as "Can't Detect Device", but the "Ademco Vista Partition 1" works fine and I can arm and disarm the system. To get this working I setup the zones, panel addresses and the serial port speed.

Is there a configuration trick to make this work?

Offline CheckedOut

  • Sr. Newbie
  • *
  • Posts: 32
  • Karma: +1/-0
Re: Can't Detect Device with Vera Plus
« Reply #1 on: March 29, 2016, 01:16:50 pm »
I actually have another issue as well. Most of the zones show up as motion sensors. Problems!

Offline CheckedOut

  • Sr. Newbie
  • *
  • Posts: 32
  • Karma: +1/-0
Re: Can't Detect Device with Vera Plus
« Reply #2 on: April 06, 2016, 04:05:24 pm »
I fixed this issue by following the advice on this thread:

http://forum.micasaverde.com/index.php/topic,36482.0.html

luup.set_failure (false, devicenumber)