I've had a Schlage keypad lever lock working perfectly on a Vera 1, then a Vera Lite, for about 7 years now. I just upgraded to a Vera Plus running UI7, and now I cannot seem to control the lock through Vera at all.
In addition, when I migrated, none of the PIN codes showed up in the device control panel. Yet, when I try to add an existing PIN code, I get an error that the PIN code is already in use. Then I went to add a new PIN code, and Vera came back with a message that the transmit was OK, and the new code was added. Yet that code doesn't show in the interface, and it DID NOT work. The code is not programmed in the lock.
My upgrade seems to have broken Vera's communication with the lock. I'm also seeing a message "Please wait, polling node" on the device screen.
When I searched the forum, I saw one post refer to older locks not working because of the "beaming" issue. But when I first got my lock several years ago, this was already a known issue, so I specifically bought a dimmer module that allegedly supports beaming, and that has been installed the whole time, and still is.
Any ideas/assistance in resolving this would be appreciated. This is a total drag - I actually rely very heavily on that gate lock to provide/control access for repair and maintenance people at my weekend home.