We have moved at community.getvera.com

Author Topic: Oregon temp sensor not autocreating  (Read 843 times)

Offline tdinardo

  • Full Member
  • ***
  • Posts: 150
  • Karma: +1/-1
Oregon temp sensor not autocreating
« on: May 15, 2016, 02:37:05 pm »
I have an Oregon THN132N temp sensor. I updated my RFXCOM USB to the latest firmware. While plugged into the PC I could see that the RFXCOM was recognizing the sensor and getting temp readings from it. When I plugged the RFXCOM back into my Vera (UI5) I could see that it was receiving data from it on the advanced tab. I have autoconfigure set to 1, but sensor device is not being auto created.

The only other device I have connected is a rollertrol blind, and that is setup and working fine.

Can anyone give me a tip on what I'm doing wrong, or if this device is just unsupported?

Offline tdinardo

  • Full Member
  • ***
  • Posts: 150
  • Karma: +1/-1
Re: Oregon temp sensor not autocreating
« Reply #1 on: May 15, 2016, 02:53:56 pm »
I changed the channel on the sensor and it then auto-created.