We have moved at community.getvera.com

Author Topic: NX-8V2 with IPdatatel BAT - Plugin  (Read 1317 times)

Offline depak74

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
NX-8V2 with IPdatatel BAT - Plugin
« on: July 04, 2016, 08:13:01 pm »
Hello All,
My setup has the 8xV2 with ipdatatel BAT module. I can control the alarm through the ipfob app on my phone.

However, I am looking to integrate the panel and zones with my vera 3. The BAT is connected to home network and even has an IP addressed assigned. Can I use this interface to communicate with the alarm panel instead of going the NX-584 route. If yes, will the plugin on this forum work for my setup as well?

Offline futzle

  • Moderator
  • Master Member
  • *****
  • Posts: 3260
  • Karma: +192/-9
Re: NX-8V2 with IPdatatel BAT - Plugin
« Reply #1 on: July 05, 2016, 12:50:15 am »
I suspect not. The plugin is hardcoded to speak over a serial connection using the NX-584 serial protocol. Unless your equipment can do that then there is no common language for your equipment and the plugin.