We have moved at community.getvera.com

Author Topic: VERA Edge UI7 MySensors plugin : Cannot send command - communications error  (Read 1159 times)

Offline co Biker

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Was wondering if anyone can help me on fixing this error message that is appearing at the top of the page when I log into my VERA controller? The system was working fine and then all of a sudden it stopped working. I have tried all the usual things, rebooting, reloading luup.. Connected directly to the gateway and the nodes and they are working as expected, and are reporting to the gateway, I am just not getting updated status on my VERA web page. Using a serial gateway. I have also, reluctantly, downloaded the new firmware version: 1.7.2043 to the VERA.. I'm pretty sure the top error (GET LANG)message has nothing to do with the comm error just because that was showing up long before the comm error showed up.. Any help would be much appreciated Thanks!!!
I have posted this question on the MySensors Forum as well.

Offline blacey

  • Sr. Member
  • ****
  • Posts: 251
  • Karma: +30/-1
Three Vera-3 (Home, Seasonal 1 & 2) - Firmware: 1.5.622,   Zwave: 3.20 L:1
One Vera-Edge (Dependent) - Firmware: 1.7.1707, Zwave: 4.5 L:1