We have moved at community.getvera.com

Author Topic: Z-Wave.Me Wall Controller (ZME_WALLC-S) with Vera firmware 1.7.2139  (Read 1185 times)

Offline Roger2016

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Hi everyone,

   I need some help to set up the  Z-Wave.Me Wall Controller with the latest firmware to control the scenes in my Veraedge.
   I want to press button 4 (bottom right) and activate a scene (#31) in Veraedge.
 
   I have tried setting the following:
   
   Configurations (Device Option of wall controller):
   Variable 1 - 0 (value)
   Variable 2 - 0 (value)
   Variable 11 - 4 (value)
   Variable 12 - 4 (value)
   Variable 13 - 4 (value)
   Variable 14 - 4 (value)

   Configurations (Scenes [under the wall controller menu])
   trigger: scene #31

   Configurations (Scenes [Vera menu])
   Scene (#31) - whenever wall controller button 4 is pressed.

   Can someone advise on what else must I do to make this work?
   Thanks in advance!

Offline trygve

  • Jr. Member
  • **
  • Posts: 83
  • Karma: +5/-1
Re: Z-Wave.Me Wall Controller (ZME_WALLC-S) with Vera firmware 1.7.2139
« Reply #1 on: October 17, 2016, 03:01:48 am »
I think you have to set variable 14 to value 8. Then associate group id 5 to the scene you want to run.
Vera Edge. Qubino flush dimmers-, 10V dimmers-, flush relays-, flush shutters-, Sunricher touch panel-, RGBW touch panel, Secure thermostats & relays, HeatIt thermostats, Fibaro RGBW dimmers, Aeotec multisensors-, Switches, Z-Wave.Me Wall Controllers, SwiidInter Cord Switch, Velux Integra, Sonos

Offline Roger2016

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Re: Z-Wave.Me Wall Controller (ZME_WALLC-S) with Vera firmware 1.7.2139
« Reply #2 on: October 17, 2016, 12:00:31 pm »
Hi trygve,

   Thanks for the advice.

   What do you mean by "Then associate group id 5 to the scene you want to run"?
   As I am a beginner, could you elaborate more on what exactly must I do and what it means after doing that step?
   I still don't see any link...for the entire setup.
   
   Thanks.