Author Topic: Sleeping devices?  (Read 1282 times)

Offline elPaulio

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Sleeping devices?
« on: October 20, 2016, 04:14:13 am »

Ive searched, but to no avail on any solid answers

I have an Aeotec ZW120 door sensor, battery powered
My Vera Edge picks it up and reports on it

That is, until it 'stops responding'
Event Entry: 'Device NOT responding'

It then takes an event (door opening) to get it to respond again
Event Entry: Device responding again
But, by this time, the door has been opened, closed and I am outside (no events recorded for that trigger)
There are no subsequent events until I trigger the sensor again by opening/closing the door

Its almost as if its going to sleep

Ive tried adjusting various settings but have yet to pin it down

Any suggestions on what I should be doing to alleviate this problem please?


Offline tomtcom

  • Beta Testers
  • Hero Member
  • *****
  • Posts: 1003
  • Karma: +23/-31
Re: Sleeping devices?
« Reply #1 on: October 22, 2016, 07:53:58 pm »
Poll settings can be 3-4 hour intervals but check the configured wakeup interval to something like 30 minutes. Both of these settings will need to be played with unless your manual has suggested settings.

Offline elPaulio

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Re: Sleeping devices?
« Reply #2 on: October 24, 2016, 04:23:19 am »
Nice one, thank you

I'll have a play

Offline gerardosamara

  • Full Member
  • ***
  • Posts: 200
  • Karma: +5/-2
Re: Sleeping devices?
« Reply #3 on: August 10, 2017, 05:03:32 pm »
Sorry @eLPolio to jump in this topic but i just got one door sensor ZW120 .

It has been integrated into my VeraEdge 7.0.22  successfully with standard settings ( param 121)
It is displayed in the UI as a sensor device and reports battery level

The issue is that the sensor does not tripped.

Before i looked a the Vera log , does yours works/trips ?

Thank you
« Last Edit: August 10, 2017, 05:07:47 pm by gerardosamara »
VeraLite+VeraEdge/EnOcean version US en UI7.1.17 + Vera Mobile UI7 V7.15.17.40 + Imperihome pro V2.8.3
Wall switch : Leviton VRS15 , Smart switch : Aeotec DSC24 , Motion sensor : Aeotec 4in1 DSB05 + Everspring HSP02 , Cameras Dlink 742L + Foscam 8910 + Foscam 9853EP

Offline XA44Owq26HxCq88

  • Full Member
  • ***
  • Posts: 148
  • Karma: +0/-1
Re: Sleeping devices?
« Reply #4 on: March 30, 2018, 04:57:35 pm »
Did this issue with your ZW120 not tripping ever get resolved? I've got the same issue - I'll open a door and the scene does not get activated. Open the door a second later and the scene gets activated. But it doesn't happen all the time. Makes the unit kinda useless.