We have moved at community.getvera.com

Author Topic: Lightning4 support (PT2262)  (Read 1443 times)

Offline Bender12

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Lightning4 support (PT2262)
« on: December 06, 2016, 04:30:07 pm »
Hi

im new to this forum so im sorry if i repost this.

Is there any way to get my 9 cheap 433mz sockets in to my Vera?
From my computer it works perfect but i cant find the settings in my Vera plus.

This is the event from RFXmngr (got the info from RFXtrx manual)
================================================
Lighting4 command
================================================
Packettype    = Lighting4
subtype       = PT2262
Sequence nbr  = 12
Code          = 454555 decimal:4539733
S1- S24  = 0100 0101 0100 0101 0101 0101
Pulse         = 425 usec
Signal level  = 0  -120dBm
------------------------------------------------
------------------------------------------------
Packettype        = Receiver/Transmitter Message
subtype           = Transmitter Response
Sequence nbr      = 12
response          = ACK, data correct transmitted

regards
Bender12

Offline hyzteric

  • Jr. Member
  • **
  • Posts: 77
  • Karma: +0/-1
Re: Lightning4 support (PT2262)
« Reply #1 on: December 18, 2016, 12:19:58 pm »
If you have the rfxtrx433E, try the EXT2 firmware with latest release 1012 and activate the X10 protocol!

Offline Frode

  • Full Member
  • ***
  • Posts: 140
  • Karma: +0/-1
Re: Lightning4 support (PT2262)
« Reply #2 on: January 26, 2017, 07:04:50 am »

Hello @Bender12,  did you manage to get the PT2262 to work with Vera? If so, what protocol?


Frode

Offline brwill

  • Sr. Newbie
  • *
  • Posts: 32
  • Karma: +0/-2
Re: Lightning4 support (PT2262)
« Reply #3 on: February 02, 2017, 10:08:07 am »
Today, I am attempting to install an RFXtrx433E with VeraLite. It seems to be configured, and in the RFXtrx settings, I have enabled Lighting4 only ( had proven with RFXmngr that my dimmer and its remote control use this protocol.) That done, I press a button on the remote and on that same pane (RFXtrx setting) the transmission is recorded accurately. I would think that this is good - Vera is getting a correct message.

But where do I go from here? None of the choices in New Device are applicable. Am I missing another LUUP file? Suggestions requested.  Thanks,
Modify message