Author Topic: Issues changing alarm panel state through Vera  (Read 2490 times)

Offline alien8er

  • Sr. Newbie
  • *
  • Posts: 28
  • Karma: +0/-0
Re: Issues changing alarm panel state through Vera
« Reply #15 on: January 09, 2017, 12:54:03 pm »
Interesting observation!  Vera support replied back to me this morning thinking that there might be some network interference.  My USB path doesn't look to be filled out in my panel, but everything else is setup the same. 

I think when I get home I might unplug some devices and see if that makes a difference.  It might be time to add a switch!

Offline alien8er

  • Sr. Newbie
  • *
  • Posts: 28
  • Karma: +0/-0
Re: Issues changing alarm panel state through Vera
« Reply #16 on: February 11, 2017, 07:27:39 pm »
I was able to follow those commands and log into the shell and issue the commands.  The commands execute just as quick as they do when I plug the AD2USB directly into my PC.  Something in the Vera interface must be interferring.  I have the new switching coming in early next week.  I don't think it will fix the issue, but I did discover that I didn't bridge my ISP's modem to my WLAN and I probably had a double NAT situation going on.  That's been resolved, but now I'm out of ports, hence the switch.

I will likely have to wipe the vera box and then start with adding just the AD2USB plugin and go from there!