Don't know if any one can help. What I am trying to do is monitor the temperature of an outside pipe. I have a pipe that that is wrapped with a heating cable and insulated but I need to know if the heating cable is not working and the pipe can freeze. I want to monitor the temperature of the pipe underneath the insulation and set an alarm so that I'll be notified if the temperature of the pipe goes below 35 degrees.
I bought a MimoLite I/O device and have attached a 10K Thermistor temperature probe to the inputs on the MiMO. I was hoping to use the contacts to light a light if the temp gets too low.
I talked to the tech rep at Fortrezz and he said the MimoLite could be used to monitor temperature by using a 10K thermistor probe like this one
https://www.amazon.com/Uxcell-Waterproof-Temperature-Thermal-Thermistor/dp/B016EYEFO2/ref=sr_1_10?ie=UTF8&qid=1483453720&sr=8-10&keywords=10k+thermistor+probeI paired the MiMoLite and installed the MIMOLite plug-in. After pairing the MIMOlite, MimoBinary Sensor, MIMOGeneric Sensor, and Mimo Pulse sensor showed up on the dashboard.
That's as far as I can get and I haven't found anything in the forum on this.
I called Fortrezz and they said it can be done but they don't do anything with software.
Thanks