Author Topic: Alarm in memory  (Read 603 times)

Offline ABuckeye

  • Newbie
  • *
  • Posts: 9
  • Karma: +1/-2
Alarm in memory
« on: March 09, 2017, 10:50:19 am »
After an alarm event I am unable to clear the system by entering the user code + off sequence twice. This has been going on since I installed the plug in a few years back, I have just put up with the minor inconvenience of power cycling the panel which clears the condition.

I have searched the forums and not found a solution, there was a similar comment a few years back on the AD2USB thread.  EVL3 and Vista 20, UI7, everything on latest versions.  The 2 keypads and EVL3 are addressed correctly.

Any ideas?

Offline cyanet

  • Newbie
  • *
  • Posts: 6
  • Karma: +0/-0
Re: Alarm in memory
« Reply #1 on: March 13, 2017, 03:38:00 pm »
It looks like i have the same setup EVL3 and Vista 20, UI7 with same issue.  However when this happens I can clear alarm from Vera Keypad (EVL3 Vista Partition)  by entering pin code and then clicking disarm.  Therefore I do not need to power cycling the panel anymore.

Offline chargernut69

  • Newbie
  • *
  • Posts: 9
  • Karma: +0/-0
Re: Alarm in memory
« Reply #2 on: March 29, 2017, 02:01:21 pm »
Had same thing happen last week....   only way I could clear the alarm panel was with my Veralite phone app.    Keypad was non-functional....