Author Topic: Vera Plus Calibration problem with Fibaro Roller Shutter module FGRM -222  (Read 397 times)

Offline Angstrom

  • Newbie
  • *
  • Posts: 4
  • Karma: +0/-0
Hi,

I am trying to calibrate my roller shutters with the Fibaro Roller Shutter 2. When I try to calibrate them, the roller shutter moves up slightly for a second, then stops and lowers again. I have set parameter 10 (motor mode) and parameter 29 (to initiate calibration).

Can anyone offer any suggestions? In another thread someone suggested it was possible to independently calibrate the modules using a light bulb. I tried doing this, but I couldnt get it to work either. I posted a follow up on that thread, but it's a bit old and I havent received any replies there.

So - can anyone help out with this? The Wife Approval Factor is hitting an all time low, since we cant control any of the shutters in the house.

Thanks!!!

Offline nickunknown

  • Newbie
  • *
  • Posts: 4
  • Karma: +0/-0
I install two fibaro with no problems.

Do you read all the parameters?

Try to first do the calibration. But now do a reset first.