Hi Angstrom,
I hope you have it working out by now, but here is how I went about setting mine up anyway.
I just installed 3 motors and 3 fibaro shutter controllers.
Step 1:
Installed motors in blinds then setup mechanic limits on motors (using an on/off light switch) left blinds in closed position.
Step 2:
Paired fibaro shutter controllers to vera edge, then wired to blind motors.
Step 3:
Set param 10 to 2 (Roller with positioning)
Step 4:
Set param 29 to 1 (Start callibration)
Blinds went up, down and up again, calibrated perfectly.
Then added scenes to close blinds at 1/4, 1/2 & 3/4 and the open, close and sliders in vera and imperihome work perfectly.
For what I understand when the fibaro controller is switched on (up or down) it closed a contact and detects motor current, when no current is detected it turns off, opening the contact. (Used to time blind from fully closed to fully open limits to set calibration)
Once calibrated its a timming thing to stop at given percentage. (Please correct me if I'm wrong)
If you click open or close does the blind open and close fully?
If it doesn't, maybe check your motor limits.