Author Topic: Ecolink Door & Motion Sensor Zwave plus  (Read 130 times)

Offline chrisacorbett

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Ecolink Door & Motion Sensor Zwave plus
« on: May 13, 2017, 09:39:09 pm »
I recently upgraded to Veraplus.  So when I needed to purchase a few door & window sensors, I purchased the Ecolink Zwave Plus device.  What's weird is that when I add it, I get two devices, one the parent of the other.  The parent device Just has an Off and on switch.  Then the child switch looks similar to my older zwave door sensors.  I can tell my sensor is connected.  Because when I move the magnet, I get a short light blink.  But Vera doesn't show any changes.  Nothing appears in the log.  And I can't get a notification to work. 

Any ideas?


Offline Jamr

  • Hero Member
  • *****
  • Posts: 561
  • Karma: +17/-8
    • 007 Systems
Re: Ecolink Door & Motion Sensor Zwave plus
« Reply #1 on: May 17, 2017, 12:47:04 am »
That is strange. I would unpair and delete all of the associated devices and pair again.