Author Topic: Pioneer receives controller  (Read 222 times)

Offline Gary S

  • Sr. Newbie
  • *
  • Posts: 27
  • Karma: +0/-0
Pioneer receives controller
« on: May 14, 2017, 09:18:27 pm »
I have a simple has anyone used the pioneer app and if so how did you get it to work? I created the device but I still can't control my receiver. Please any help would be greatly appreciated.

Offline tehtruth

  • Newbie
  • *
  • Posts: 8
  • Karma: +0/-1
Re: Pioneer receives controller
« Reply #1 on: June 01, 2017, 05:53:02 pm »
if you check in the official vera "app store" you will see a version of the pioneer receiver plugin there.  if you install it from there then simply put in the IP address under the "Advanced" then "Params" tab you will be good to go after reloading luup engine. 

also, I have some custom scenes that I trigger and talk to the receiver over TCP/IP (telnet).

local socket = require("socket")
tcp = assert(socket.connect("IPAddressHere", port#))
tcp:send("19FN" .. "\r\n")
tcp:close()

that will switch the input to what maps to 19FN (DVI in most cases).