Author Topic: ZXT-120  (Read 190 times)

Offline Alireza44907

  • Jr. Member
  • **
  • Posts: 52
  • Karma: +0/-0
ZXT-120
« on: August 20, 2017, 06:24:03 am »
Hello all

I have a heater that works with IR.
When I want to turn it on I have to push and hold its On/Off button of its remote control for almost 3 seconds.

Other actions such as increasing and decreasing flame and turning of is just a simple click by its remote. I can do all these actions with ZXT-120 after learning IR codes to it but not "turning it on" action.

Is there anyway to do this action using ZXT-120? I want to turn the heater on using ZXT-120.
It must send the specific IR code for 3 seconds continuously as if On/Off button of heater in pushed and hold.

Offline Alireza44907

  • Jr. Member
  • **
  • Posts: 52
  • Karma: +0/-0
Re: ZXT-120
« Reply #1 on: August 21, 2017, 03:20:38 am »
Is it possible to send an IR code using ZXT-120 and Vera in a Lua Code?

Offline agrinberg

  • Newbie
  • *
  • Posts: 10
  • Karma: +0/-0
Re: ZXT-120
« Reply #2 on: November 11, 2017, 03:59:43 am »
looking for same answer.
is it possible to send Lua code via ZXT-120 on vera?