Author Topic: Schlage shown as Poly-Control Danalock in devices  (Read 88 times)

Offline n8huntsman

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Schlage shown as Poly-Control Danalock in devices
« on: September 07, 2017, 11:57:29 am »
I added a Schlage lock in devices.  Everything worked perfect, the on screen directions worked and matched the Schlage user manual.  After adding, when I go to my devices, It is shown as "Poly-Control Danalock"
Im certain I selected Schlage, the directions for the danalock are very different.  Everything is working fine just wanted to point it out and see if anyone has noticed.  Is there anywhere I can change that?

Offline kartcon

  • Jr. Member
  • **
  • Posts: 53
  • Karma: +1/-0
Re: Schlage shown as Poly-Control Danalock in devices
« Reply #1 on: September 07, 2017, 08:42:41 pm »
I also have two Kwikset locks that show up the same way. They work just fine so I was willing to overlook the naming oddity but wondered if it was something that could eventually be corrected.

Offline kendad

  • Full Member
  • ***
  • Posts: 127
  • Karma: +1/-4
Re: Schlage shown as Poly-Control Danalock in devices
« Reply #2 on: September 08, 2017, 12:24:37 am »
I have the same issue with my Schlage and my Chamberlain MyQ garage door openers. I asked support about it and they said "please note that I?ve addressed this matter to our development department". Guess that means it should be corrected in some later firmware upgrade.