Author Topic: 10 Channel Z-UNO  (Read 670 times)

Offline Stiansen

  • Newbie
  • *
  • Posts: 18
  • Karma: +2/-0
10 Channel Z-UNO
« on: December 01, 2017, 01:59:50 pm »
Good morning Zedrally,

A short note to let you know that I was able to load the 10 Channel sketch, so now begins my adventure into a new experience, I will keep you posted.

Dom

Hi

Can you guide me through how you did this? I also got it included as a dimmer, but when I try to upload the 10 channel code the vera wont detect it anymore. Did you restart anything?

I also have a question regardin future changes to the code (add or remove objects). Do you need to disconnect the z-uno from the z-wave network and include it again when you do changes or how does it work actually? 

Thank you!!

Stian


Offline Michal

  • Newbie
  • *
  • Posts: 13
  • Karma: +1/-0
Re: 10 Channel Z-UNO
« Reply #1 on: December 05, 2017, 07:06:25 am »
Good morning Zedrally,

A short note to let you know that I was able to load the 10 Channel sketch, so now begins my adventure into a new experience, I will keep you posted.

Dom

Hi

Can you guide me through how you did this? I also got it included as a dimmer, but when I try to upload the 10 channel code the vera wont detect it anymore. Did you restart anything?

I also have a question regardin future changes to the code (add or remove objects). Do you need to disconnect the z-uno from the z-wave network and include it again when you do changes or how does it work actually? 

Thank you!!

Stian

Hi Stian,
You have to do exclusion+inclusion each time you change channel settings (number of channels, type, var sizes etc).
If you only change internal Arduino code then you don't have to.

I already have 2 successful Z-Uno projects in my network. One collects temperature from 4 sensors and CO2 sensor. The other one is used for read out of electricity and gas meter (using pulses to detect consumption).  ;)