Author Topic: Switching to upgrade page but no upgrade available  (Read 536 times)

Offline backkri

  • Jr. Member
  • **
  • Posts: 65
  • Karma: +1/-0
Switching to upgrade page but no upgrade available
« on: December 24, 2017, 05:09:55 am »
When I connect to my VeraPlus, it switches to the upgrade page automatically.  But then, it says:

Checking if there is a newer firmware version available

 You are running the latest version 1.7.3232

This makes no sense, what is going on?

Offline dalhoj

  • Sr. Newbie
  • *
  • Posts: 30
  • Karma: +2/-0
Re: Switching to upgrade page but no upgrade available
« Reply #1 on: December 24, 2017, 06:22:14 am »
Same here !!!

Regards:-)

Offline ranneman

  • Full Member
  • ***
  • Posts: 142
  • Karma: +7/-0
Re: Switching to upgrade page but no upgrade available
« Reply #2 on: December 24, 2017, 06:34:04 am »
This is due to an issue with the latest release. It is not a perfect solution but in this way support blocks installing the latest firmware (which messes op your system).
Vera lite UI7 Europe, Vera Plus, Zwave.me switches/dimmers, Zwave.me plus multi switch, Fibaro switches and multi sensors, Everspring sensors motion, temp., humidity. Honeywell Evohome, Greenwave, Sonos, Brel shades, RFXCOM, MiLights, Alexa.

Offline Sammy2

  • Hero Member
  • *****
  • Posts: 870
  • Karma: +5/-5
Re: Switching to upgrade page but no upgrade available
« Reply #3 on: December 27, 2017, 02:22:10 pm »
It'd be nice if the fine folks at micasaverde would let it load directly to the dashboard rather than to the upgrade page when there's no upgrade. As a matter of fact, I never want it to load to that page. I don't apply upgrades for several days after they are released to avoid potential fails (like last week).