Author Topic: Fibaro Single/Double Switch 2 FGS-2x3 Energy Monitoring  (Read 636 times)

Offline sameri

  • Jr. Member
  • **
  • Posts: 54
  • Karma: +1/-0
Fibaro Single/Double Switch 2 FGS-2x3 Energy Monitoring
« on: January 17, 2018, 07:02:20 pm »
Hi All,

This is possibly an extremely dumb question. I did a search online and on this forum but couldn't find an answer...

How do I get the active power reading (wattage) for a Fibaro Single/Double Switch 2 FGS-2x3 to show up on a Vera Edge?

I've also got a Fibaro Home Center and the wattage is just displayed clear as day on the device's overview but I can't find it on Vera.

Apologies again if this is a stupid question but any help would be greatly appreciated.

Cheers,
Sam.
SA Home Automation | Affordable Home Automation in South Australia | www.sahomeautomation.com.au

Offline kwieto

  • Hero Member
  • *****
  • Posts: 570
  • Karma: +27/-14
Re: Fibaro Single/Double Switch 2 FGS-2x3 Energy Monitoring
« Reply #1 on: January 18, 2018, 06:33:05 am »
Should be visible under device name, in the left top quarter of the device panel.
If the device is not used, it shows "0" as a usage (i.e. "0.0 Watts").
From my experience, sometimes it takes couple of minutes after pairing to see such writing.
I have FGS-223 and it presents readings correctly

Offline sameri

  • Jr. Member
  • **
  • Posts: 54
  • Karma: +1/-0
Re: Fibaro Single/Double Switch 2 FGS-2x3 Energy Monitoring
« Reply #2 on: January 18, 2018, 06:30:55 pm »
Thanks for that.

That is where I thought it should be present but couldn't see it. Device has been paired for weeks.

Would you have a screenshot showing it to make sure I'm looking in the correct spot?
SA Home Automation | Affordable Home Automation in South Australia | www.sahomeautomation.com.au