We have moved at community.getvera.com

Author Topic: Z-Wave Temerature and Humidity Sensor EVR ST814  (Read 3125 times)

Offline Farriers

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Z-Wave Temerature and Humidity Sensor EVR ST814
« on: January 29, 2011, 01:07:43 pm »
Can anyone help a novice please?  I have just managed to set up, to my amazement A Vera Z - wave controller to switch on lights in various locations, switch on an Aga, an immersion heater however i have now hit a wall!!  I have been told to install a EVR ST814 which i want to link to switch on the boiler.  Both icons are on the vera desk top and functioning but i just can't get the grouping?? right to get the thermostat to switch the boiler which is set up on a Appliance plug!

Any help really greatly appreciated but be gentle please i am struggling with some of the jargon!

Offline SquareConnectMat

  • Full Member
  • ***
  • Posts: 248
  • Karma: +0/-0
Re: Z-Wave Temerature and Humidity Sensor EVR ST814
« Reply #1 on: January 29, 2011, 09:45:07 pm »
@farriers

I think this is a question best asked on the general Vera forum. This section is really centered around SQ Remote and how it interacts with Vera.

If I undertake correctly, what you want will best accomplished using the scenes and events with the Vera system.

Mat

Offline huogas

  • Sr. Member
  • ****
  • Posts: 301
  • Karma: +0/-0
Re: Z-Wave Temerature and Humidity Sensor EVR ST814
« Reply #2 on: April 03, 2011, 10:48:23 am »
@Farriers

Are you set up ?
Vera2 UI4(1.1.1245/3.2), Kwikset x1, HM-DW001 x1, ZRP100 x1, HA-04WD x1, ZDP100 x6, HSM100 x2, VRI06-1LX x8, ZW5301 x1, HM-FS001 x2, ZRW103W x1, GE 45606 x2, HA05C x1, TED5000 x1