Author Topic: Garage door + qubino flush 1D relay  (Read 56 times)

Offline Grzyber

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Garage door + qubino flush 1D relay
« on: August 15, 2018, 07:41:17 am »
Hi Guys!

Longer time reader but that's my first post so I would like to start from hello ;)

I have just started cofiguration of my Vera Plus (fw 1.7.4001) and I want to control (open/close) my garage door which now is opening by Faac D600 motor with E600 control board. I do not have external wall switch to open/close my gate (just the internal on the motor box). What i found so far is to use dry contact relay and I bought Qubino Flush 1D Relay (ZMNHND1). E600 control board has 24VDC output so I can feed my Qubino relay.

Can you tell if my understanding of wiring is OK? Please see attachment below.

I got and info from Qubino support:
"It will only control opening of the door, to control closing of the door you will need another flush 1d relay or a physical switch."
What You think? Do I really need two 1D relays?

Additional sources:
Faac D600 motor manual: http://www.faac.se/fileadmin/templates/fileserver/manualer/Garageportar/D600/Bruksanvisning_D600_Eng.pdf
Qubino Flush 1D manual: https://www.vesternet.com/mwdownloads/download/link/id/1137/product/1477/z_wave_qubino_flush_1d_relay_plus_user_manual_v1_2.pdf

I will be grateful for any advice.

Offline Sammy2

  • Hero Member
  • *****
  • Posts: 855
  • Karma: +4/-5
Re: Garage door + qubino flush 1D relay
« Reply #1 on: August 16, 2018, 03:43:57 pm »
I use Garage Door Control Plugin and a FortrezZ MIMO Lite to control mine perfectly, up and down.